Skip to product information
Case Length Headspace Gauge
For: 303 British
CG-303B
NEW!!!
"The gauge allows you to see just how much you are sizing back."
One piece gauge that will check overall length to indicate the need for trimming,
datum to head length to assure correct headspace and to prevent oversizing.
Available for most popular rimless cases.
Note:Â
Does not measure body diameters.
This gauge is intended to be used with fired cases
to determine a basis for full length sizing and trimming.
L.E. Wilson has been making precision reloading tools forÂ
over 80 years.Â
The Case Length Headspace Gauge allows reloaders toÂ
measure case length from the base of the cartridge to the shoulder,
 as well as the maximum case length.Â
This process shows the reloader if ammunition is being producedÂ
within specifications.
Technical Information
Material: Steel
Features: Precision Machining
Notes:
This is a one-piece, non-adjustable cylinder-type gauge for checking
 fired and resized cartridge cases for cone-to-head and overall length
Used to compare cartridges against the minimum SAAMIÂ
chamber dimensions
The item description will indicate if the headspace gauge is Adjustable
Instructions:
Drop a fired case into the gauge.Â
Take a measurement on headspace.Â
This can be done with either a depth micrometer or caliper
 (Depending on if the case is sitting high or low in the gauge).Â
If the case sticks out past maximum headspace the firearm probably
 has a larger than average chamber.Â
The gauge can still be used because it is being used to determine
 how much resizing is required.
Now once the initial measurement is taken, slowly dial in theÂ
full length sizer until there is a 0.001 to 0.002 drop in headspace.Â
This will give the measurement to resize the case just below the chambers headspace in the firearm being reloaded for, giving a more accurate shot and saving brass by not causing it to be overworked.
Once the brass has been sized, set the brass in the gauge and setÂ
the gauge on a flat surface with the head side facing down.
Now look across the top of the gauge, this give the maximum andÂ
minimum for trim length.
~~~~~~~~~~~~~~~~~~~~~
|
We are unable to accept returns on used, fitted, or altered parts.Â
Returns must be in new, unused condition and in their original packaging.